|
Step 1: Pull down the screen slowly and gently;
Step 2: Connect the mouse cable-from the wall socket, labeled "mouse"-to remote control jack #7
(see figure 0 and figure 1).
Step 3: Push POWER button #1 on the remote control panel(see figure 0) once and wait about a minute or
you do other things.
Step 4: Connect the CRT cable-from the wall socket, labeled "computer 1" or "computer 2"-to your own
computer or to the computer Wyoming(see figure 2).
Step 5: Now you can open your computer and start. If the signal does not come out on the screen, you
can push the COMPUTER button #2(see figure 0), it will switch to the other channel-push this button the
input signal will switch between computer 1 and computer 2-you use one of them.
Step 6: Now the signal should come out; otherwise, the connecting is not correct; check again until the
content of the demo computer's screen come to the proxima's screen.
Step 7: If the image on the pulldown screen is not good; push the AUTO-POSITION button #3 (see figure 0).
Step 8: After use, please turn off the proxima: first bush the POWER button #1(see figure 0); after that
you will see the prompt message "POWEROFF? YES: PRESS AGAIN", so just press the POWER button again and
the proxima should turn off.
Step 9: Lift the screen; and leave the connections as they are. |
